But when I put the old ram in the computer doesn’t recognize there is ram in the slot. I’m going to get new sticks of ram for this prebuilt that are DDR3 just because this ram has already given me problems in the past. I just want to make sure I didn’t damage my mobo or new ram for my new build. Thank you for any response!!!! Hi Madhur, I recently upgraded my pc having 4gb RAM with an additional 4gb RAM with 64bit OS. It worked fine for 4 days. Then the old ram got faulty. I tested in both the slots but didnt work. I tried the OVEN method yet it didnt work. Is it a case of incompatibility. Can this RAM be repaired or should i go for a new one. It is possible all the memory modules are damaged if your computer experienced a serious power surge. If all the memory modules appear bad, then the problem is likely with the memory slot itself. Try testing each memory module in each of the memory slots to find if one of the slots is faulty.
To check the new RAM wasn't defective, I tried it in slot 1, a known good slot. All 4 sticks of RAM worked in slot 1, so the RAM wasn't faulty. All 4 sticks work in every slot except slot 2 (the first black RAM slot). If I put any stick in slot 2 - old or new - the PC is dead, it won't even boot to the BIOS. Swap or rearrange RAM chips: If you have access to the RAM chips on your system, swap or rearrange them, especially if you have more than two available RAM slots (as you do on some iMac models.
Is it possible to fix laptop memory slot failure with a guitar pick? Yes, it is. You will not fix the memory slot itself, but you can work around the problem. 🙂
Today I received a Toshiba Satellite Pro 4600 laptop with the following complaint:
The laptop starts and works properly, but recognizes only one of the two memory modules installed. The laptop has two 256MB RAM modules installed, but registers only 256MB.
First of all, I removed the memory cover to find out if both memory modules are installed correctly. The laptop had two 256MB Kingston modules installed and they were seated properly.
When I started the laptop and entered the BIOS setup menu, I found that only one of the two memory modules is detected and the laptop registers only 256MB (262144KB) of RAM instead of 512MB (524288KB).
Just a side note. In the computer world 1MB=1024KB. That’s why 256MB=262144KB and 512MB=524288KB.
I tried reseating both memory modules but it didn’t help.
After that I tried installing both memory modules in both memory slots one by one and here’s what I found. The laptop worked absolutely fine when both memory modules were installed into the slot A, but failed to boot with both memory modules installed into the slot B.
Apparently, there is nothing wrong with the memory modules and the laptop has a faulty memory slot B. The memory slot is permanently soldered on the motherboard. If one of the slots fails you’ll have to replace the whole motherboard or use the laptop with only one working slot.
Buying a new motherboard for this older laptop wouldn’t make any sense because it’s too expensive, but the laptop is still in a good working condition except the faulty memory slot B, so I continued playing with that trying to find the solution.
I noticed that the laptop start normally with the memory module installed into the faulty slot if I slightly press on the module with my thumb. And this gave me an idea.
Broken Ram Slot
This guitar pick is going to fix my laptop. 🙂
I installed both RAM modules back into the slots and then placed the guitar pick over the module in the slot B as it shown on the picture.
I thought if I close the RAM door it will press on the guitar pick/memory module and it will have the same effect as pressing on the module with my thumb. And it worked!
Broken Ram Slot Clip
Both memory modules were detected properly and the laptop registered all 512MB. After “the fix” I tested memory with Memtest86+ and the laptop passed the test.
I wouldn’t call it the best solution for fixing a faulty memory slot but in some cases it will work.
By the way, I didn’t charge the customer for this “repair”, he knows what is going on and how I “fixed” his problem.
Broken Ram Slot Macbook Pro
I've got an Asus P5B Deluxe motherboard. Today I tried adding some new RAM to take it from 4GB to 8GB. The board is about 6 years' old. I've never used the black RAM slots before, only the yellow ones (2x2GB in slots 1 and 3).
My system only sees 6GB, not 8GB. I've tried various combinations of the RAM, get the same result.
To check the new RAM wasn't defective, I tried it in slot 1, a known good slot. All 4 sticks of RAM worked in slot 1, so the RAM wasn't faulty.
All 4 sticks work in every slot except slot 2 (the first black RAM slot). If I put any stick in slot 2 - old or new - the PC is dead, it won't even boot to the BIOS.
So it looks like I have a defective RAM slot.
Does anyone know of any way to fix this? The board is too old to RMA. I've tried an emery board down the defective slot, and I've tried squirting WD40 down it. No improvement.
Does anyone have any other ideas on how to get that bad slot working?
Thanks!